Our Square Loaf Mould makes a rectangular Log of soap weighing just over a kilo. This mould is completely leak-proof, so is ideal for Melt & Pour Soap.
Suitable for Cold Process, Rebatch and Melt & Pour Soap Making - see below for usage instructions. If using for CP, follow temperature guidelines and use and care instructions carefully or the mould will warp.
Holds 1180mls (approximately 1.3kg)
23.5cm x 7cm deep x 8.9cm wide
Makes 8 x 1.9cm slices (or 7 x 2cm slices)
Usage Information:
This mould is made of 0.04mil clear plastic which is more durable than the industry standard 0.03 mil.
For easier unmoulding, only fill to within ½ cm of mould edge
Maximum Pouring Temperature: 62ºC (145ºF)
Warping can occur if pouring at higher temperatures. Setting mould in a shallow cold-water bath is recommended for hot-temperature pours
Allow Melt and Pour Soaps to set up for at least 1 – 2 hours before releasing from mould – the soap must be completely cold and at room temperature
Avoid excessive force when releasing soap from mould
Using your fingertips, gently pull the sides of mould away from the soap until you see air pockets forming. Flip mould over and firmly, but gently push down on the mould until the soap drops out onto work surface.
